3D Printed Phone Stand

I made a phone holder with a small hole below it, so I can do a video call while my phone is still charging. Also, this is my first time 3d printing, and I got a lot of support from the staff, who are very helpful and knowledgeable.

A lesson learned: It is somewhat surprising that a thing this small can take over 2 hours to print. Also, when designing support for his model, the default one overlapped the body of the holder. After switching to the organic support, the support went around the body and solved the problem. But, at the end one leg of the support was misplaced, fortunately, it did not cause too much of a problem.

Here is a link to the original model.

https://www.printables.com/model/1395671-elevate-phone-holder

A charging Apple Iphone sitting on a yellow 3D printed phone stand. The stand is triangular; the back side has a hole for the charger, and the front side has two hooks to hold the phone while not blocking the port.

My finished 3D Printed phone holder.

Yellow 3D printed phone holder on the 3D printer bed. The phone holder is laying on its side, and has a little brim of yellow plastic around it on the printbed.

Hot off the press! This is the phone holder immediately after printing.